TELEMATICS SYSTEM(w/ Telematics Transceiver), Diagnostic DTC:B15DE

DTC Code DTC Name
B15DE Telematics Transceiver Location Data Blackout

DESCRIPTION

The telematics transceiver checks the reception condition of the location data every minute after the engine switch is turned on (ACC). If the location data is not received from the radio receiver assembly for 5 minutes, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15DE Telematics Transceiver Location Data Blackout Location information from USB communication is interrupted
  • Harness or connector

  • Telematics transceiver

  • Radio receiver assembly

WIRING DIAGRAM

A01XNRIE03

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK.

Click here

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
    2. Recheck for DTCs and check if the same DTC is output again.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      Result
      Result Proceed to
      No DTCs are output. A
      B15DB and B15DE are output. B
      Only B15DE is output. C

    A
    B
    C
  2. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - RADIO RECEIVER ASSEMBLY)


    1. Check the installation condition.


      1. Check the USB communication lines (digital communication cable) between the radio receiver assembly and the telematics transceiver for any installation or connection problems.

    2. Disconnect the I98 radio receiver assembly connector.

    3. Disconnect the I100 telematics transceiver connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I98-4 (USBV) - I100-4 (USBV) Always Below 1 Ω
      I98-2 (USBG) - I100-2 (USBG) Always Below 1 Ω
      I98-1-2 (USB+) - I100-1-2 (USB+) Always Below 1 Ω
      I98-1-1 (USB-) - I100-1-1 (USB-) Always Below 1 Ω
      I98-1-3 (USBS) - I100-1-3 (USBS) Always Below 1 Ω
      I100-4 (USBV) - Body ground Always 10 kΩ or higher
      I100-2 (USBG) - Body ground Always 10 kΩ or higher
      I100-1-2 (USB+) - Body ground Always 10 kΩ or higher
      I100-1-1 (USB-) - Body ground Always 10 kΩ or higher
      I100-1-3 (USBS) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. REPLACE TELEMATICS TRANSCEIVER


    1. Replace the telematics transceiver.

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  4. CHECK DTC OUTPUT


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
    2. Recheck for DTCs and check if the same DTC is output again.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      Result
      Result Proceed to
      B15DE is not output. A
      B15DE is output. B

    A
    B