NAVIGATION SYSTEM, Diagnostic DTC:B1575

DTC Code DTC Name
B1575 GVIF Disconnected (from EMV/MM Integrated Device to Multi Display)

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B1575 GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) GVIF disconnected (from radio receiver assembly to multi-display assembly)

  • Harness and connector (GVIF cable)

  • Radio receiver assembly

WIRING DIAGRAM

B0057EIE01
*a Multi-display Assembly
*b Radio Receiver Assembly
*c GVIF Cable

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click here

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK DTC


    1. Recheck for DTCs and check if the same DTC is output again.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (GVIF CABLE)


    1. Check that the digital signal lines between the multi-display assembly and radio receiver assembly are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.

      OK
      There are no installation problems.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE HARNESS AND CONNECTOR (GVIF CABLE)

    OK

  4. REPLACE HARNESS AND CONNECTOR (GVIF CABLE)


    1. Replace the harness and connector (GVIF cable).

      Result
      Proceed to
      NEXT

    NEXT

  5. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  6. CHECK DTC


    1. Recheck for DTCs and check if the same DTC is output again.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    END (GVIF CABLE IS DEFECTIVE)

    NG

  7. REPLACE MULTI-DISPLAY ASSEMBLY


    1. Replace the multi-display assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  9. CHECK DTC


    1. Recheck for DTCs and check if the same DTC is output again.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here