NOISE FILTER REMOVAL

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY (for Manual Seat)

    Click here

  2. REMOVE REAR SEAT ASSEMBLY (for Power Seat)

    Click here

  3. REMOVE TONNEAU COVER ASSEMBLY

    Click here

  4. REMOVE DECK BOARD ASSEMBLY

    Click here

  5. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY

    Click here

  6. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  8. REMOVE SPARE TIRE (w/ Spare Tire)

    Click here

  9. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  10. REMOVE DECK FLOOR BOX LH (w/o Spare Tire)

    Click here

  11. REMOVE DECK FLOOR BOX RH (w/ Spare Tire)

    Click here

  12. REMOVE DECK FLOOR BOX RH (w/o Spare Tire)

    Click here

  13. REMOVE NO. 1 TOOL BOX SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  14. REMOVE NO. 1 TOOL BOX SUB-ASSEMBLY (w/o Spare Tire)

    Click here

  15. REMOVE NO. 2 TOOL BOX SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  16. REMOVE NO. 2 TOOL BOX SUB-ASSEMBLY (w/o Spare Tire)

    Click here

  17. REMOVE REAR FLOOR FINISH PLATE

    Click here

  18. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  19. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  20. REMOVE UPPER DECK TRIM SIDE BOARD LH

    Click here

  21. REMOVE ROPE HOOK ASSEMBLY

    Click here

  22. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  23. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  24. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  25. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  26. REMOVE RADIO SETTING CONDENSER

    Note

    When a terminal cover is removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.


    1. B0057CY

      Remove the bolt.

    2. Detach the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. B00577J

      Detach the claw and pull out the cover as shown in the illustration.

    4. B00574V

      Using a screwdriver, detach the 6 claws and remove the 2 terminal covers with wire harness from the condenser.

    5. B0059ZA

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    6. Remove the terminal cover from the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.