AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display), Diagnostic DTC:B1574

DTC Code DTC Name
B1574 GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device)

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B1574 GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device) GVIF disconnected (from parking assist ECU to multi-display assembly)

  • Harness or connector (GVIF cable)

  • Multi-display assembly

  • parking assist ECU

WIRING DIAGRAM

B00580WE09

CAUTION / NOTICE / HINT

Tech Tips

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs

    2. Turn the engine switch off.

    3. Recheck for DTCs and check that no DTCs are output.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - PARKING ASSIST ECU)


    1. B0058U3C19
      *a

      Front view of wire harness connector

      (to Multi-display Assembly)
      *b

      Front view of wire harness connector

      (to Parking Assist ECU)

      Disconnect the I173 multi-display assembly connector.

    2. Disconnect the P48 radio receiver assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      P48-1 (GVO+) - I173-1 (GVI+) Always Below 1 Ω
      P48-2 (GVO-) - I173-2 (GVI-) Always Below 1 Ω
      P48-3 (GVG1) - I173-3 (GVG1) Always Below 1 Ω
      P48-1 (GVO+) - Body ground Always 10 kΩ or higher
      P48-2 (GVO-) - Body ground Always 10 kΩ or higher
      P48-3 (GVG1) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK MULTI-DISPLAY ASSEMBLY


    1. Replace the multi-display assembly with a new or known good one.

      Click here

    2. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs

    3. Turn the engine switch off.

    4. Recheck for DTCs and check that no DTCs are output.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)

    NG

    REPLACE PARKING ASSIST ECU Click here