TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM


    1. Disable the auto tilt away function by changing the customize parameter.

      Click here

      Note

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the auto tilt away function to be disabled when the ignition switch is turned off.

    2. Turn the ignition switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  5. REMOVE LOWER STEERING COLUMN COVER


    1. B005868

      Remove the 3 screws.

    2. B0058TX

      Detach the 2 claws and remove the lower steering column cover.

      Note

      Do not damage the tilt and telescopic switch.

  6. REMOVE TILT AND TELESCOPIC SWITCH

    B0057X8

    1. Disconnect the connector.

    2. Detach the claw and pull out the tilt and telescopic switch.

      Note

      Pushing on the claw too hard will break the claw.