STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY


    1. Secure the electric power steering column sub-assembly in a vise.

    2. Using a center punch, mark the center of the tapered-head bolts.

    3. Using a 3 to 4 mm (0.119 to 0.157 in.) diameter drill bit, drill a hole in the tapered-head bolt.

    4. B005ALGC01
      *a Screw Extractor

      Using a screw extractor, remove the tapered-head bolt, and then remove the steering lock actuator assembly from the electric power steering column sub-assembly.

  2. REMOVE WIRE HARNESS BRACKET


    1. B0057D5C01
      B005BAD Place Hand Here
      B00599Y Remove in this Direction (1)
      B0059HQ Remove in this Direction (2)

      Lift in the direction (1) indicated by the arrow shown in the illustration, and pull in the direction (2) to detach the claw.

    2. B00574QC01
      B00599Y Remove in this Direction

      Pull in the direction indicated by the arrow to detach the guide and remove the bracket from the steering column assembly.

  3. REMOVE POWER STEERING ECU ASSEMBLY

    Click here

  4. REMOVE POWER STEERING MOTOR ASSEMBLY


    1. B0059VB

      Remove the 2 bolts and power steering motor assembly.