FRONT BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

Note

If the RH side flexible hose and LH side flexible hose are both removed from the vehicle at the same time, place an identification mark on each hose so that it can be reinstalled to its original position.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. DRAIN BRAKE FLUID

    Note

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  3. REMOVE FRONT FLEXIBLE HOSE


    1. w/ AVS:


      1. A01XPHZN03

        Disconnect the brake tube labeled A from the flexible hose using a union nut wrench while holding the front flexible hose with a wrench.

        Note


        • Do not bend or damage the brake tube.

        • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

      2. Remove the clip labeled B.

      3. A01XOYTN01

        Remove the bolt labeled D, speed sensor clamp and flexible hose bracket from the steering knuckle.

      4. A01XO08C02
        *1 Flexible Hose Clamp
        *2 Sensor Clamp

        Remove the bolt labeled C, and then remove the front speed sensor bracket and front flexible hose braket from the absorber bracket in that order.

    2. w/o AVS:


      1. A01XOLPN01

        Disconnect the brake tube labeled A from the front flexible hose using a union nut wrench while holding the flexible hose with a wrench.

        Note


        • Do not bend or damage the brake tube.

        • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

      2. Remove the clip labeled B.

      3. Remove the bolt labeled D and flexible hose bracket from the steering knuckle.

      4. A01XPB4C02
        *1 Front Flexible Hose Bracket
        *2 Front Speed Sensor Bracket

        Remove the bolt labeled C, and then remove the front speed sensor bracket and front flexible hose bracket from the absorber bracket in the order.

    3. A01HIHR

      Remove the union bolt and gasket, and then remove the front flexible hose from the disc brake cylinder assembly LH.