BRAKE MASTER CYLINDER(for RHD) INSPECTION

PROCEDURE


  1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD


    1. A01HEJBC02
      *1 Accessory Tool
      *a Apply Chalk

      Apply chalk to the tip of the accessory tool.

      Tech Tips

      An accessory tool is included with a new brake master cylinder sub-assembly.

    2. Place the accessory tool on the brake booster assembly.

    3. Measure the clearance between the brake booster push rod and accessory tool.

      Standard clearance
      0 mm (0 in.)

      Tech Tips

      Adjust the clearance in the following cases:


      • If there is a clearance between the accessory tool and the shell of the brake booster (floating accessory tool), the push rod is protruding too far.

      • If the chalk does not stick on the tip of the brake booster push rod, the push rod protrusion is insufficient.

    4. A01HEOTE01

      If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

      SST
      09737-00020

      Note

      Check the push rod clearance again after adjusting.