REAR SPEED SENSOR(for 2WD) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. RELEASE PARKING BRAKE

    Click here

  2. REMOVE REAR WHEEL

    Click here

  3. REMOVE NO. 2 TOOL BOX SUB-ASSEMBLY

    Click here

  4. REMOVE REAR SKID CONTROL SENSOR WIRE LH (w/ AVS)


    1. B005A6O

      Disconnect the 2 connectors.

    2. Disconnect the grommet of the rear skid control sensor wire LH from the hole of the wheel house.

    3. B0057CP

      Remove the bolt and sensor clamp from the side member.

    4. B0058BEN01

      Disconnect the connector.

    5. Remove the nut, and then remove sensor clamp A together with sensor clamp B from the upper arm.

    6. Remove the nut and sensor clamp C from the upper arm.

    7. B0059DMN01

      Remove the nut, and then remove sensor clamp A together with sensor clamp B.

    8. Remove the bolt and sensor clamp.

    9. Disconnect the connector from the skid control sensor.

  5. REMOVE REAR SKID CONTROL SENSOR WIRE LH (w/o AVS)


    1. B00596K

      Disconnect the connector.

    2. Disconnect the grommet of the rear skid control sensor wire LH from the hole of the wheel house.

    3. B00570K

      Remove the bolt and sensor clamp from the side member.

    4. Remove the 2 nuts and 2 sensor clamps from the upper arm.

    5. B00597O

      Remove the bolt and sensor clamp.

    6. Disconnect the connector from the skid control sensor.

  6. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

    Click here

  7. REMOVE REAR DISC

    Click here

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH

    Click here