BRAKE PEDAL(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  4. REMOVE UPPER INSTRUMENT PANEL

    Click here

  5. REMOVE STOP LIGHT SWITCH ASSEMBLY

    Click here

  6. REMOVE BRAKE PEDAL RETURN SPRING


    1. Remove the brake pedal return spring from the brake pedal support.

  7. REMOVE PUSH ROD PIN


    1. Remove the clip from the push rod pin.

    2. Remove the push rod pin from the push rod clevis.

  8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. B00585MC01
      *1 Instrument Panel Reinforcement
      *2 Brake Pedal Support

      Remove the brake pedal support reinforcement set bolt.

    2. B0057V2

      Remove the 4 nuts and brake pedal support assembly.

  9. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

    Click here

  10. REMOVE BRAKE PEDAL PAD


    1. Remove the brake pedal pad from the brake pedal support assembly.