TIRE PRESSURE WARNING INITIATOR(for Rear Side) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

  2. REMOVE REAR WHEEL (for LH Side)

    Click here

  3. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

    Click here

  4. REMOVE REAR BUMPER SIDE SEAL LH


    1. A01OF3W

      Remove the 2 clips and rear bumper side seal LH.

  5. REMOVE REAR WHEEL HOUSE FRONT PLATE LH


    1. A01OF5SC01
      B0057RX Clip
      B0059IK Screw

      Remove the 2 clips, screw and rear wheel house front plate LH.

  6. REMOVE REAR WHEEL HOUSE LINER LH


    1. A01OEWWC01
      B0057RX Clip (A)
      B0059IK Clip (B)

      Remove the 3 clips (A), 9 clips (B) and rear wheel house liner LH.

  7. REMOVE REAR TIRE PRESSURE MONITOR INITIATOR


    1. A01OEV1

      Remove the service hole cover, and then disconnect the connector of the rear tire pressure monitor initiator.

    2. A01HGDV

      Disconnect the grommet.

    3. Remove the 2 nuts and rear tire pressure monitor initiator.