PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Tech Tips
The installation location of the tire pressure warning receiver differs depending on the vehicle. For more details about the installation location, refer to the following.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE REAR SEAT ASSEMBLY
for Manual Seat: Click here
for Power Seat: Click here
REMOVE TONNEAU COVER ASSEMBLY
REMOVE DECK BOARD ASSEMBLY
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY
REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)
REMOVE SPARE TIRE (w/ Spare Tire)
REMOVE DECK FLOOR BOX LH (w/ Spare Tire)
REMOVE DECK FLOOR BOX LH (w/o Spare Tire)
REMOVE DECK FLOOR BOX RH (w/ Spare Tire)
REMOVE DECK FLOOR BOX RH (w/o Spare Tire)
REMOVE NO. 1 TOOL BOX SUB-ASSEMBLY (w/ Spare Tire)
REMOVE NO. 1 TOOL BOX SUB-ASSEMBLY (w/o Spare Tire)
REMOVE NO. 2 TOOL BOX SUB-ASSEMBLY (w/ Spare Tire)
REMOVE NO. 2 TOOL BOX SUB-ASSEMBLY (w/o Spare Tire)
REMOVE REAR FLOOR CARPET (w/o Spare Tire)
REMOVE REAR FLOOR FINISH PLATE
REMOVE BATTERY SERVICE COVER BOARD
for Manual Seat: Click here
for Power Seat: Click here
REMOVE NO. 1 SEAT LEG ASSEMBLY
for Manual Seat: Click here
for Power Seat: Click here
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
REMOVE ROPE HOOK ASSEMBLY
REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
REMOVE UPPER DECK TRIM SIDE BOARD RH
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH
REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Remove the bolt.
Detach the 2 guides to remove the tire pressure warning ECU and receiver.
Disconnect the connector from the tire pressure warning ECU and receiver.