TIRE PRESSURE WARNING INITIATOR(for Rear Side) INSTALLATION

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read precaution thoroughly before servicing.

   Click here

2. INSTALL REAR TIRE PRESSURE MONITOR INITIATOR

   
   

   1. Install the rear tire pressure monitor initiator with the 2 nuts.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

   2. Connect the grommet.

   3. Connect the connector of the rear tire pressure monitor initiator and install the service hole cover.

3. INSTALL REAR WHEEL HOUSE LINER LH

   
   

   1. Install the rear wheel house liner LH with the 3 clips (A) and 9 clips (B).

4. INSTALL REAR WHEEL HOUSE FRONT PLATE LH

   
   

   1. Install the rear wheel house front plate LH with the screw and 2 clips.

5. INSTALL REAR BUMPER SIDE SEAL LH

   
   

   1. Install the rear bumper side seal LH with the 2 clips.

6. INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

   Click here

7. INSTALL REAR WHEEL (for LH Side)

   Click here

8. INSPECT TIRE PRESSURE WARNING SYSTEM

   Click here