WHEEL OPENING MOULDING(for Rear) REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL NO. 5 MOULDING TAPE


    1. Clean the No. 5 moulding tape installation surface with a non-residue solvent.

    2. Apply primer to the No. 5 moulding tape installation area on the quarter outside moulding sub-assembly LH.

      Note

      Apply primer evenly so that there are no uncoated areas.

    3. Remove the peeling paper on a new No. 5 moulding tape while making sure not to touch the adhesional surface.

    4. A01HIHB

      Install a new No. 5 moulding tape in the position shown in the illustration.

      Note


      • Press the double-sided tape on the No. 5 moulding tape firmly to attach.

      • After the primer dries (3 minutes or more), install the No. 5 moulding tape.

      • After applying primer, reapply primer after 24 hours elapse.

  2. INSTALL REAR LOWER QUARTER MOULDING PROTECTOR LH


    1. Clean the rear lower quarter moulding protector LH installation surface with a non-residue solvent.

    2. Apply primer to the rear lower quarter moulding protector LH installation area on the quarter outside moulding sub-assembly LH.

      Note

      Apply primer evenly so that there are no uncoated areas.

    3. Remove the peeling paper on a new rear lower quarter moulding protector LH while making sure not to touch the adhesional surface.

    4. A01HJ8OC01
      *1 Mark-off Line
      *a 3.0 mm (0.118 in.)
      *b 1.0 mm (0.0394 in.)

      Install a new rear lower quarter moulding protector LH in the position shown in the illustration.

      Note


      • Press the double-sided tape on the rear lower quarter moulding protector LH firmly to attach.

      • After the primer dries (3 minutes or more), install the rear lower quarter moulding protector LH.

      • After applying primer, reapply primer after 24 hours elapse.