SIDE MUDGUARD INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SIDE MUDGUARD SUB-ASSEMBLY LH

    Tech Tips

    When installing the side mudguard sub-assembly LH, heat the vehicle body and side mudguard sub-assembly LH using a heat light.

    Standard
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Side Mudguard Sub-assembly LH 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or side mudguard sub-assembly LH excessively.


    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the back door panel.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Install the side mudguard sub-assembly LH.


      1. Using a heat light, heat the vehicle body.

      2. Remove the peeling paper from the face of the No. 3 moulding tape.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. A01HEPEC01
        *1 No. 3 Moulding Tape

        Attach the 2 clips so as to apply the No. 3 moulding tape and install the side mudguard sub-assembly LH as shown in the illustration.

        Tech Tips

        Press the side mudguard sub-assembly LH firmly to install it.

    3. Install a new grommet.

    4. Install the clip.

    5. Install the screw.