REAR BUMPER REMOVAL

CAUTION / NOTICE / HINT

w/ Blind Spot Monitor System:

Tech Tips

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not be operating correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click here

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE


  1. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

    Click here

  2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE NO. 5 MOULDING TAPE

    Click here

  4. REMOVE REAR LOWER QUARTER MOULDING PROTECTOR LH

    Click here

  5. REMOVE REAR FLOOR SIDE MEMBER COVER


    1. B0058KR

      Remove the 8 clips and rear floor side member cover.

  6. REMOVE REAR BUMPER NO. 1 PLATE


    1. B0059JJ

      Detach the 2 claws and remove the rear bumper No. 1 plate.

      Tech Tips

      Use the same procedure for all rear bumper No. 1 plates.

  7. REMOVE REAR BUMPER COVER


    1. B005972

      Remove the clip.

      Tech Tips

      Use the same procedure to remove the clip on the other side.

    2. B0059J7C01
      B0057KY Protective Tape

      Put protective tape around the rear bumper cover.

    3. Remove the 4 screws labeled A.

    4. Remove the 2 screws labeled B.

    5. w/ LEXUS Parking Assist-sensor System, w/ Hands Free Power Back Door, w/ Rear Fog Light:


      1. Disconnect the connector.

    6. Detach the 16 claws and remove the rear bumper cover.

      B00575HC03
      *a Screw A *b Screw B

  8. REMOVE REAR BUMPER NO. 1 REINFORCEMENT


    1. B0057MD

      Remove the 8 bolts and rear bumper No. 1 reinforcement.

  9. REMOVE REAR BUMPER SIDE SEAL LH


    1. B0059TF

      Remove the 2 grommets and rear bumper side seal LH.

  10. REMOVE REAR BUMPER SIDE SEAL RH

    Tech Tips

    Use the same procedure described for the LH side.

  11. REMOVE REAR BUMPER SIDE SUPPORT LH


    1. B005AYHC03
      *a 90°

      Remove the screw.

    2. Using a screwdriver, turn the clip 90° and detach the clip.

    3. Detach the 2 claws and remove the rear bumper side support LH.

  12. REMOVE REAR BUMPER SIDE SUPPORT RH

    Tech Tips

    Use the same procedure described for the LH side.