STOP LIGHT SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER (for Plastic Type)


    1. B0059GB

      Attach the 2 claws to install a new stop light switch mounting adjuster.

  2. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. B0059QA

      for Plastic Type:


      1. Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

        Note

        Do not depress the brake pedal.

      2. B0059CUC01
        *a Protrusion Amount Measurement Area

        Rotate the stop light switch assembly clockwise by approximately one fourth of a rotation.

      3. Check the protrusion amount of the shaft.

        Standard
        0.5 to 2.6 mm (0.0197 to 0.1024 in.)

      4. Connect the connector.

    2. B0057EGC01
      *a Protrusion Amount Measurement Area

      for Metal Type:


      1. Turn the stop light switch assembly in the clockwise direction until it reaches the standard shaft protrusion amount and temporarily install it.

        Standard
        0.5 to 1.7 mm (0.0197 to 0.0669 in.)

        Note

        Do not depress the brake pedal.

      2. B005B69C03
        *a Torque Wrench Fulcrum Length
        *b Union Nut Wrench

        Using a union nut wrench and a torque wrench, tighten the lock nut.

        Torque
        Specified tightening torque
        16.7 N*m (170 kgf*cm, 12 ft.*lbf)

        Tech Tips


        • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

          Click here

        • When using union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 14.4 N*m (147 kgf*cm, 11 ft.*lbf)

      3. Connect the connector.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. INSTALL COWL SIDE TRIM BOARD LH

    Click here

  5. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  6. INSPECT STOP LIGHT


    1. Depress the brake pedal and check that the stop light illuminates.