PROCEDURE
PRECAUTION
Note
Be sure to read Precaution thoroughly before servicing.
Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.
Do not reuse parts which have reduced fastening ability due to thread damage.
When installing components, make sure that the wire harness is not pinched or pulled.
Do not use solvent to clean components. Only clean them with a dry cloth.
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
REMOVE HEADLIGHT ASSEMBLY LH
for Single Beam Headlight:
for Triple Beam Headlight:
REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH
Note
If the headlight light control ECU sub-assembly has been dropped, replace it with a new one.
If the headlight light control ECU sub-assembly LH has been removed, replace the headlight gasket with a new one.
When removing the headlight light control ECU sub-assembly LH, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
Remove the 3 screws and headlight light control ECU sub-assembly LH.
Disconnect the connector cover.
| *A | for Triple Beam Headlight |
Disconnect each connector.
REMOVE HEADLIGHT GASKET
Note
If the headlight gasket has been removed, replace it with a new one.
When removing the headlight gasket, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
Remove the headlight gasket.