REAR TURN SIGNAL LIGHT BULB REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT COVER LH

    Click here

  2. DISCONNECT REAR COMBINATION LIGHT ASSEMBLY LH


    1. B005B84

      Remove the 2 bolts.

    2. B0058I8C01
      B0057KY Protective Tape

      Apply protective tape around the rear combination light assembly LH.

    3. Pull the rear combination light assembly LH towards the rear of the vehicle to detach the pin and 3 guides and disconnect it.

      Note

      Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.

  3. REMOVE REAR TURN SIGNAL LIGHT BULB


    1. B00573MC01
      *1 Matchmark
      *2 Unlock Position Mark
      B0057RX Counterclockwise

      Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock position mark to disconnect the bulb socket.

    2. B0058I1

      Remove the rear turn signal light bulb from the bulb socket.

  4. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. B0057SY

      Install the rear turn signal light bulb to the bulb socket.

    2. B005761C01
      *1 Matchmark
      *2 Unlock Position Mark
      *3 Lock Position Mark
      B0057RX Clockwise

      Align the matchmark of the bulb socket to the unlock position mark, and then rotate the bulb socket clockwise until the lock position mark to connect the bulb socket.

  5. CONNECT REAR COMBINATION LIGHT ASSEMBLY LH


    1. B0057IR

      Attach the 3 guides and pin to connect the rear combination light assembly LH.

    2. Install the 2 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  6. INSTALL REAR COMBINATION LIGHT COVER LH

    Click here

  7. INSPECT REAR COMBINATION LIGHT

    Click here