REAR COMBINATION LIGHT ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • Perform work using clean rubber gloves.

    • Do not touch the rear combination light socket and wire sub-assembly LH connector with bare hands.

    SST
    09890-47010   ( 09891-04010, 09891-04020, 09891-04030, 09891-04040 )

    1. Attach the 2 wire harness clamps to install the rear combination light socket and wire sub-assembly LH.

    2. Connect the connector.

    3. B0059X5

      Rotate the connector cap clockwise until it stops to connect the connector cap.

  2. INSTALL REAR COMBINATION LIGHT RETAINER LH


    1. B0057RKC01
      *a Wire Harness Clamp
      *b Guide

      Attach the 2 guides to Install the rear combination light retainer LH.

    2. Attach the wire harness clamp.