REAR COMBINATION LIGHT ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH


    1. Attach the 2 wire harness clamps to install the rear combination light socket and wire sub-assembly LH.

    2. Connect the connector.

    3. A01HJ6WC01
      *1 Matchmark
      *2 Unlock Position Mark
      *3 Lock Position Mark
      B0057RX Clockwise

      Align the matchmark of the connector cap to the unlock position mark, and then rotate the connector cap clockwise until the lock position mark to connect the connector cap.

  2. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. A01HFEJ

      Install the rear turn signal light bulb to the bulb socket.

    2. A01HJ7RC01
      *1 Matchmark
      *2 Unlock Position Mark
      *3 Lock Position Mark
      B0057RX Clockwise

      Align the matchmark of the bulb socket to the unlock position mark, and then rotate the bulb socket clockwise until the lock position mark to connect the bulb socket.