CLEARANCE LIGHT ASSEMBLY(for Bulb Type Turn Signal Light) INSPECTION

PROCEDURE


  1. INSPECT CLEARANCE LIGHT ASSEMBLY LH


    1. B0059D8C03
      *a

      Component without harness connected

      (Clearance Light Assembly LH)

      Apply battery voltage to the connector and check the light illumination condition.

      OK
      Condition Specified Condition

      Battery positive (+) → A30-3 (DRL)

      Battery negative (-) → A30-2 (E)

      		 LED illuminates

      Battery positive (+) → A30-4 (DRLC)

      Battery negative (-) → A30-2 (E)

      		 LED illuminates in dimmed state

      If the result is not as specified, replace the clearance light assembly LH.

  2. INSPECT CLEARANCE LIGHT ASSEMBLY RH


    1. A01HDSGC05
      *a

      Component without harness connected

      (Clearance Light Assembly RH)

      Apply battery voltage to the connector and check the light illumination condition.

      OK
      Condition Specified Condition

      Battery positive (+) → A31-3 (DRL)

      Battery negative (-) → A31-2 (E)

      		 LED illuminates

      Battery positive (+) → A31-4 (DRLC)

      Battery negative (-) → A31-2 (E)

      		 LED illuminates in dimmed state

      If the result is not as specified, replace the clearance light assembly RH.