REAR COMBINATION LIGHT ASSEMBLY DISASSEMBLY

PROCEDURE


  1. PRECAUTION

    Note


    • Be sure to read Precaution thoroughly before servicing.

      Click here

    • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to rear combination light assembly components.

    • Do not reuse parts which have reduced fastening ability due to thread damage.

    • Do not touch the inner surface of the lens and metallic surfaces as much as possible, or they may become dirty

    • Do not allow metallic surfaces to become dirty, as such surfaces become damaged even if they are only lightly wiped with a soft cloth.

    • When installing components, make sure that the wire harness is not pinched or pulled.

    • Do not use solvent to clean components. Only clean them with a dry cloth.

    Tech Tips


    • Use the same procedure for the RH and LH sides.

    • The procedure listed below is for the LH side.

  2. REMOVE REAR COMBINATION LIGHT RETAINER LH


    1. B0057RKC01
      *a Wire Harness Clamp
      *b Guide

      Detach the wire harness clamp.

    2. Detach the 2 guides and remove the rear combination light retainer LH.

  3. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • Perform work using clean rubber gloves.

    • Do not touch the rear combination light socket and wire sub-assembly LH connector with bare hands.

    SST
    09890-47010   ( 09891-04010, 09891-04020, 09891-04030, 09891-04040 )

    1. B00592B

      Turn the connector cap counterclockwise until it stops to disconnect the connector cap.

    2. B0059EN

      Disconnect the connector.

    3. B0057YP

      Detach the 2 wire harness clamps and remove the rear combination light socket and wire sub-assembly LH.