AUTOMATIC HIGH BEAM SYSTEM PRECAUTION

PRECAUTION FOR AUTOMATIC HIGH BEAM SYSTEM

1. Windshield Replacement Precautions

   The timing of the high beams turning on and off differs depending on the light transmission rate of the glass. For this reason, when replacing the windshield, replace it with an original equipment part.

2. Lane departure warning camera Handling Precautions

   Failure to observe the following precautions may result in a malfunction:

   
   

   • Do not touch the lens of the lane departure warning camera with bare hands.

   
   

   • Do not allow anything to adhere to the lane departure warning camera lens.

   
   

   • Do not apply strong impacts to the lane departure warning camera.

   
   

   • Do not allow any liquid to contact the lane departure warning camera.

   
   

   • Do not apply excessive force when installing, removing, or replacing the lane departure warning camera. Doing so may deform the lane departure warning camera, bracket.

   
   

   • Do not use a deformed lane departure warning camera.

   
   

   • Replace the windshield glass when the bracket is deformed or damaged.

   
   

   • Do not use a lane departure warning camera that has been dropped.

   
   

   • Make sure to wear clean cotton gloves or equivalent when installing or removing the lane departure warning camera as they will not function properly if oil adheres to the part.

   
   

   • Do not pull on the wire harness when disconnecting the lane departure warning camera connector.