LIGHTING SYSTEM Turn Signal Switch Circuit

DESCRIPTION

The combination meter receives the turn signal switch information and controls the turn signal lights.

WIRING DIAGRAM

B005A17E01

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, make sure to replace it with a new one.

PROCEDURE


  1. READ VALUE USING GTS (TURN SIGNAL SWITCH)


    1. Using the GTS, read the Data List.

      Click here


      Body Electrical > Combination Meter > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Turn Signal Switch (Right) Turn signal switch (right) signal ON or OFF

      ON: Turn signal switch (right) on

      OFF: Turn signal switch (right) off

      		 -
      Turn Signal Switch (Left) Turn signal switch (left) signal ON or OFF

      ON: Turn signal switch (left) on

      OFF: Turn signal switch (left) off

      		 -

      Body Electrical > Combination Meter > Data List
      Tester Display
      Turn Signal Switch (Right)
      Turn Signal Switch (Left)
      Result
      Result Proceed to
      Data List values are as specified A
      Data List values are not as specified B

    A

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    B

  2. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (TURN SIGNAL SWITCH)


    1. Remove the headlight dimmer switch assembly.

      Click here

    2. Inspect the headlight dimmer switch assembly.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)


    1. Disconnect the I126*1 or I31*2 headlight dimmer switch assembly connector.

      *1: for LH Side Type

      *2: for RH Side Type

    2. Disconnect the I11 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LH Side Type
      Tester Connection Condition Specified Condition
      I126-11 (TL) - I11-4 (EL) Always Below 1 Ω
      I126-12 (TR) - I11-3 (ER)
      I126-13 (CR) - I11-8 (SW)
      I126-15 (EL) - Body ground
      I126-11 (TL) - Body ground Always 10 kΩ or higher
      I126-12 (TR) - Body ground
      I126-13 (CR) - Body ground
      for RH Side Type
      Tester Connection Condition Specified Condition
      I31-19 (TL) - I11-4 (EL) Always Below 1 Ω
      I31-20 (TR) - I11-3 (ER)
      I31-18 (CR) - I11-8 (SW)
      I31-16 (EL) - Body ground
      I31-19 (TL) - Body ground Always 10 kΩ or higher
      I31-20 (TR) - Body ground
      I31-18 (CR) - Body ground
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR