RAIN SENSOR INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY (RAIN SENSOR CIRCUIT)


    1. Remove the map light assembly.

      Click here

    2. A01HIINC02
      *a

      Component without harness connected

      (Map Light Assembly (Rain Sensor Circuit))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T6-1 (IG) - T6-14 (IG2) Always Below 1 Ω
      T6-21 (GND2) - T6-19 (GND)

      If the result is not as specified, replace the map light assembly.

    3. Install the map light assembly.

      Click here