STOP AND START SYSTEM CHECK MODE PROCEDURE

Tech Tips

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode.

Note

All the stored DTCs and freeze frame data are cleared if: 1) the engine stop and start ECU is switched from normal mode to check mode or vice versa; or 2) the engine switch is turned from on (IG) to on (ACC) or off while in check mode. Before changing modes, always check for and note any DTCs and freeze frame data.


  1. CHECK MODE PROCEDURE


    1. Check and ensure the following conditions:


      1. Battery voltage is 11 V or higher.

      2. Shift lever is in P or N.

      3. A/C switch is off.

    2. Turn the engine switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the engine switch on (IG).

    5. Turn the GTS on.

    6. Enter the following menus: Powertrain / Stop and Start / Utility / Check Mode.


      Powertrain > Stop and Start > Utility
      Tester Display
      Check Mode

    7. Switch the engine stop and start ECU from normal mode to check mode.

    8. B0057TKE01
      *1 0.13 seconds
      *2 ON
      *3 OFF

      Check that the stop and start cancel indicator light flashes as shown in the illustration.

    9. Start the engine.

    10. Check that the stop and start cancel indicator light turns off.

    11. Simulate the conditions of the malfunction described by the customer.

    12. Check for DTCs and freeze frame data using the GTS.