OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

   
   

   1. Remove any oil from the threads of the oil pressure sender gauge assembly.

   2. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.

      Note

      Do not let adhesive adhere to the oil hole.

   3. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:

      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

   4. Connect the oil pressure sender gauge assembly connector.

2. INSPECT FOR OIL LEAK

   Click here