INTAKE AIR CONTROL VALVE REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 2 AIR CLEANER HOSE


    1. A01XP4S

      Slide the clamp and disconnect the No. 4 ventilation hose from the No. 2 air cleaner hose.

    2. Loosen the 2 hose clamps and remove the No. 2 air cleaner hose.

  3. REMOVE COMPRESSOR INLET ELBOW


    1. A01XO9C

      Disconnect the air by-pass valve assembly connector and wire harness clamp.

    2. A01XO7U

      Remove the 2 nuts and compressor inlet elbow from turbocharger sub-assembly.

    3. A01XPBQ

      Using an E8 "TORX" socket wrench, remove the stud bolt shown in the illustration together with the compressor inlet elbow and gasket.

  4. REMOVE AIR BY-PASS VALVE ASSEMBLY


    1. A01XO34

      Using a T30 "TORX" socket wrench, remove the 3 bolts and air by-pass valve assembly shown in the illustration.

      Note

      Replace with a new part if the part is dropped or subjected to a strong impact.