FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  3. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  5. REMOVE V-RIBBED BELT

    Click here

  6. REMOVE CRANKSHAFT PULLEY


    1. B005APAC01
      *a Hold
      B0057RX Turn

      Using SST, hold the crankshaft pulley and loosen the crankshaft pulley set bolt until 2 or 3 threads are screwed into the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. B005A2MC05
      *a Hold
      B0057RX Turn

      Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley and crankshaft pulley set bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply lubricant to the threads and end of SST.

  7. REMOVE TIMING CHAIN COVER OIL SEAL


    1. B0057JCC08
      *a Protective Tape

      Using a screwdriver, pry out the timing chain cover oil seal.

      Note


      • Do not damage the surface of the timing chain cover oil seal press fit hole or the crankshaft.

      • After removing the timing chain cover oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.