REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. A01HJM0E02

      Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the rear engine oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the edges of the cylinder block sub-assembly and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01HGHMN09

      Using SST, hold the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. Clean the bolts and bolt holes.

    3. A01HHCYC01
      *1 Front Drive Plate Spacer (Reversible)
      *2 Drive Plate and Ring Gear Sub-assembly
      *3 Rear Drive Plate Spacer
      *a Engine Side
      *b Transaxle Side

      Install the front drive plate spacer.

    4. Install the drive plate and ring gear sub-assembly and the rear drive plate spacer to the crankshaft.

      Tech Tips


      • The front drive plate spacer is reversible.

      • As the rear drive plate spacer and the drive plate and ring gear sub-assembly are not reversible. be sure to install them so that they are facing in the direction shown in the illustration.

    5. Apply a few drops of adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01HIKBN01

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY