REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. A01HGEDC02
      *a Depth

      Using SST, evenly tap in the rear engine oil seal until the seal is flush with the edge of the cylinder block.

      SST
      09223-15030   ( 09951-07150 )
      Standard depth
      -0.45 to 0.45 mm (-0.0177 to 0.0177 in.)

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01HDUCN02

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the bolts and their installation holes.

    3. A01HE28C02
      *a Pin Hole
      *b Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01HJM6C02
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      *a Automatic Transaxle Side

      Install the drive plate and ring gear sub-assembly and the rear drive plate spacer to the crankshaft.

      Note

      As the rear drive plate spacer and the drive plate and ring gear sub-assembly are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    5. A01HHRXC89
      *a Adhesive

      Apply a few drops of adhesive to 2 or 3 threads at the end of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01HH3UN02

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY


  4. INSPECT FOR OIL LEAK

    Click here