DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT

    Tech Tips

    When reusing the fan and generator V belt, check the entire belt for wear and cracks on the ribs and back of the belt. Replace any belts with wear or cracks that have reached the core (at 1 point or more) and belts with missing rubber ribs (at 1 point or more).


    1. A01HHT8C01
      *1 Crankshaft Pulley
      *2 Engine Water Pump Assembly
      *3 Generator Assembly
      *4 Compressor Assembly with Pulley
      *5 Idler Pulley Sub-assembly

      Set the fan and generator V belt onto each pulley as shown in the illustration.

      Note

      Make sure the back of the fan and generator V belt is set to the V-ribbed belt tensioner assembly and engine water pump assembly.

    2. Using a tool, turn the pulley set bolt of the V-ribbed belt tensioner assembly counterclockwise, and then remove the 5 mm hexagon wrench.

    3. A01HEH4

      Check that the fan and generator V belt is set correctly to each pulley.

    4. Start the engine and check that the fan and generator V belt rotates smoothly and quietly.

  2. INSTALL REAR ENGINE UNDER COVER RH


    1. Install the rear engine under cover RH with the 4 clips.