FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. A01OEV4C01
      *a -0.75 to -1.45 mm (-0.0295 to -0.0571 in.) (from edge of the timing chain cover assembly)

      Using SST and a hammer, tap in the timing gear case or timing chain case oil seal until the timing chain cover edge.

      SST
      09636-20010
      Standard depth
      -0.75 to -1.45 mm (-0.0295 to -0.0571 in.) (from edge of the timing chain cover assembly)

      Note


      • Do not tap in the timing gear case or timing chain case oil seal at an angle.

      • Keep the lip free from foreign matter.

      • Wipe off any MP grease from the crankshaft.

  2. INSTALL CRANKSHAFT PULLEY ASSEMBLY

    Click here

  3. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  4. INSTALL FAN AND GENERATOR V BELT

    Click here

  5. INSPECT FOR OIL LEAK

    Click here

  6. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here