ACCELERATOR PEDAL ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.


      Powertrain > Engine and ECT > Data List
      Tester Display
      Accel Sensor Out No.1
      Accel Sensor Out No.2

    5. Read the value displayed on the GTS.

      Standard Voltage
      Accel Sensor Out No. 1
      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V
      Standard Voltage
      Accel Sensor Out No. 2
      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.