CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL CAMSHAFT POSITION SENSOR

   
   

   1. Apply a light coat of engine oil to the O-ring.

   2. Install the 2 camshaft position sensors with the 2 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      
      

      • When reusing the camshaft position sensor, check the O-rings.

      • Make sure that the O-ring is not cracked or jammed when installing it on the cylinder head cover sub-assembly.

      • Replace with a new part if it is dropped or if it receives a strong impact.

   3. Connect the 2 camshaft position sensor connectors.

   4. Connect the fuel pump assembly connector.

2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

   Click here