SFI SYSTEM(w/o Canister Pump Module), Diagnostic DTC:P01152A

DTC Code DTC Name
P01152A Engine Coolant Temperature Sensor 1 Signal Stuck in Range

DESCRIPTION

Refer to DTC P011511.

Click here

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P01152A Engine Coolant Temperature Sensor 1 Signal Stuck in Range

When either of the following conditions is met (2 trip detection logic).


  • When engine is started cold and warmed up, the engine coolant temperature sensor value does not change.

  • After the warmed up engine is stopped and the next cold engine start is performed, the engine coolant temperature sensor value does not change.

  • Thermostat

  • Engine coolant temperature sensor

 Comes on DTC stored SAE: P0116

MONITOR DESCRIPTION



MONITOR STRATEGY

Required Sensors/Components Engine coolant temperature sensor
Frequency of Operation Once per driving cycle

CONFIRMATION DRIVING PATTERN

B0058G5E73

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG) and turn the GTS on.

  3. Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature.

  4. Check that the engine coolant temperature is 60°C (140°F) or less.

  5. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  6. Turn the engine switch off and wait for at least 30 seconds.

  7. Turn the engine switch on (IG) and turn the GTS on [A].

  8. Start the engine and idle it for 5 minutes or more [B].

    Tech Tips

    If the engine coolant temperature does not change by 5°C (9°F) or higher, the engine coolant temperature sensor is malfunctioning. It is not necessary to continue this procedure.

  9. Enter the following menus: Powertrain / Engine / Trouble Codes [C].

  10. Read the pending DTCs.

    Tech Tips


    • If a pending DTC is output, the system is malfunctioning.

    • If a pending DTC is not output, perform the following procedure.

  11. Enter the following menus: Powertrain / Engine / Utility / All Readiness.

  12. Input the DTC: P01152A.

  13. Check the DTC judgment result.

    GTS Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions
    N/A

    • Unable to perform DTC judgment

    • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

    • If the judgment result shows INCOMPLETE or N/A, perform steps [D] and [E].

  14. Drive the vehicle at 40 km/h (25 mph) or more for a total of 5 minutes or more [D].

    CAUTION:

    When performing the confirmation driving pattern, obey all speed limits and traffic laws.

    Tech Tips

    In the event of the drive pattern being interrupted (possibly due to factors such as traffic conditions), the drive pattern can be resumed.

  15. Check the DTC judgment result again [E].

    Tech Tips

    If the judgment result shows INCOMPLETE or N/A, perform steps [D] and [E] again.

CAUTION / NOTICE / HINT

Tech Tips


  • If any of DTCs P011511, P011515 or P012500 are output simultaneously with DTC P01152A, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.

  • Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

  • When the DTC is output, check the engine coolant temperature using the GTS. Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature. If the Coolant Temperature value is lower than the actual engine coolant temperature, the engine coolant temperature sensor circuit may be malfunctioning. In this case, check the wire harnesses and connectors (and those connections) between the ECM and the engine coolant temperature sensor first.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P01152A)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Read the DTCs.


      Powertrain > Engine > Trouble Codes
      Result
      Result Proceed to
      DTC P01152A is output A
      DTC P01152A and other DTCs are output B

      Tech Tips

      If any DTCs other than P01152A are output, troubleshoot those DTCs first.


    B

    GO TO DTC CHART Click here

    A

  2. INSPECT THERMOSTAT


    1. Inspect the thermostat (opening temperature).

      Click here

      Tech Tips

      Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

      Click here

      Result
      Proceed to
      OK
      NG

    OK

    REPLACE ENGINE COOLANT TEMPERATURE SENSOR Click here

    NG

    REPLACE THERMOSTAT Click here