REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. REMOVE REAR AXLE SHAFT NUT LH (for AWD)

    A01XOOHN02

    1. Using SST and a hammer, unstake the staked part of the rear axle shaft nut.

      SST
      09930-00010   ( 09931-00010, 09931-00020 )

      Note

      Loosen the staked part of the rear axle shaft nut completely, otherwise the screw of the drive shaft may be damaged.

    2. While applying the brakes, remove the rear axle shaft nut.

  3. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  4. REMOVE REAR DISC

    Click here

  5. DISCONNECT REAR SKID CONTROL SENSOR WIRE LH (for 2WD)


    1. w/ AVS:

      Click here

    2. w/o AVS:

      Click here

  6. DISCONNECT REAR SPEED SENSOR LH (for AWD)


    1. w/ AVS:

      Click here

    2. w/o AVS:

      Click here

  7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (for 2WD)


    1. A01XP4M

      Remove the 4 bolts and the rear axle hub and bearing assembly.

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (for AWD)

    A01XPCY

    1. Remove the 4 bolts from the rear axle carrier.

    2. Using a plastic-faced hammer, remove the rear axle hub and bearing assembly LH.