REAR AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  3. REMOVE REAR DISC

    Click here

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A01OEZX

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub assembly.

  5. INSPECT REAR AXLE HUB RUNOUT


    1. A01OETH

      Using a dial indicator, check for runout on the surface of the axle hub inside the rear axle hub bolt.

      Maximum
      0.07 mm (0.00276 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub assembly.

  6. INSTALL REAR DISC

    Click here

  7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  8. INSTALL REAR WHEEL

    Click here