REAR AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH


    1. B00592Z

      Disconnect the parking brake wire from the rear disc brake caliper assembly LH.

    2. A01OEET

      Remove the 2 bolts, and disconnect the rear disc brake caliper assembly.

      Note

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  3. REMOVE REAR DISC

    Click here

  4. REMOVE REAR AXLE HUB BOLT LH

    A01OEJEC02
    *1 Nut
    *a Hold
    *b Turn

    1. Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.

    2. Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

      SST
      09611-12010

  5. INSTALL REAR AXLE HUB BOLT LH

    A01OE13C02
    *1 Washer
    *2 Nut
    *a Hold
    *b Turn

    1. Install a washer and nut to a new rear axle hub bolt as shown in the illustration.

    2. Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

  6. INSTALL REAR DISC

    Click here

  7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH


    1. Connect the rear disc brake caliper assembly LH with the 2 bolts.

      Torque:
      104 N*m  { 1061 kgf*cm, 77 ft.*lbf }

    2. Connect the parking brake wrie to the rear disc brake caliper assembly LH.

  8. INSTALL REAR WHEEL

    Click here