REAR DRIVE SHAFT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH


    1. Install a new rear drive shaft inboard joint shaft snap ring LH.

      Note


      • Do not damage the spline of the rear drive shaft inboard joint assembly LH.

      • The rear drive shaft inboard joint shaft snap ring LH should be installed completely.

  2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH


    1. Coat the spline of the rear drive shaft inboard joint assembly LH with Toyota Genuine Differential gear oil LT.

    2. Coat the snap ring of the rear drive shaft inboard joint assembly LH with MP grease.

    3. A01HHL2C01
      *a Opening

      Align the splines of the rear drive shaft inboard joint assembly LH and, using a brass bar and hammer, tap in the rear drive shaft assembly LH.

      Note


      • Using MP grease, set the rear drive shaft inboard joint shaft snap ring LH in the groove with the opening facing downwards and centered radially.

      • Do not damage the rear drive shaft oil seal LH and drive shaft inboard joint boot.

      • Make sure to follow the proper handling and installation procedures. If the rear drive shaft assembly LH is installed at too large an angle or slides too much, it may fall out of the groove of the tripod joint.

      • Do not tap the end of the rear drive outboard joint shaft assembly LH with a hammer, etc.

      Tech Tips

      Determine whether or not the rear drive shaft assembly LH is completely tapped in by checking for changes in sound or the reaction force of the brass bar.

  3. ADD DIFFERENTIAL OIL

    Click here

  4. INSPECT FOR OIL LEAK

  5. INSTALL REAR AXLE CARRIER LH

    Click here

  6. INSTALL REAR WHEEL

    Click here