4WD CONTROL SWITCH INSPECTION

PROCEDURE


  1. REMOVE NO. 2 COMBINATION SWITCH ASSEMBLY

    Click here

  2. INSPECT NO. 2 COMBINATION SWITCH ASSEMBLY


    1. B0059RBC02
      *a

      Component without harness connected

      (No. 2 Combination Switch Assembly (AWD Lock Mode Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      6(B) - 18(GND) ON Below 1 Ω
      OFF 10 kΩ or higher

      If the result is not as specified, replace the No. 2 combination switch assembly (AWD lock mode switch).

    2. B0058LZC02
      *a

      Component without harness connected

      (No. 2 Combination Switch Assembly (AWD Lock Mode Switch))
      *b No. 2 Combination Switch Assembly (AWD Lock Mode Switch) Illumination

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the No. 2 combination switch assembly (AWD lock mode switch).

      Standard
      Measurement Condition Specified Condition

      Battery positive (+) → 8 (ILL+)

      Battery negative (-) → 15 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the No. 2 combination switch assembly (AWD lock mode switch).

  3. INSTALL NO. 2 COMBINATION SWITCH ASSEMBLY

    Click here