CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM Pattern Select Switch Sport Mode Circuit

DESCRIPTION

The ECM memory contains programs for normal and sport shift patterns.

By following the programs corresponding to signals from the integration control & panel assembly (pattern select switch), park/neutral position switch and various other sensors, the ECM switches the shift control solenoid valves on and off, and controls the transaxle gear ratio.

WIRING DIAGRAM

B0059HKE03
*a SPCN
*b Integration Control & Panel Assembly (Pattern Select Switch)

CAUTION / NOTICE / HINT

Note


  • Perform initialization when parts related to the continuously variable transaxle are replaced.

    Click here

  • Check that no DTCs are stored after performing initialization.

    Click here

PROCEDURE


  1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY (PATTERN SELECT SWITCH)


    1. B0057ULC20
      *1 Integration Control & Panel Assembly (pattern select switch)

      Remove the integration control & panel assembly (pattern select switch).

      Click here

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      7 (P) - 1 (GND) Pattern select switch being turned and held at SPORT position Below 1 Ω
      7 (P) - 1 (GND) Pattern select switch not turned 10 kΩ or higher
      8 (B) - 1 (GND) Pattern select switch being pushed and held Below 1 Ω
      8 (B) - 1 (GND) Pattern select switch not pushed 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE INTEGRATION CONTROL & PANEL ASSEMBLY (PATTERN SELECT SWITCH) Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL & PANEL ASSEMBLY - BODY GROUND)


    1. B00576YC03
      *a

      Front view of wire harness connector

      (to Integration Control & Panel Assembly (pattern select switch))

      Disconnect the integration control & panel assembly (pattern select switch) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I66-1 (GND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL & PANEL ASSEMBLY - ECM)


    1. B0058STC18
      *a

      Front view of wire harness connector

      (to ECM)

      Disconnect the ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      A35-57 (PWMS) - Body ground Pattern select switch being turned and held at SPORT position Below 1 Ω
      A35-57 (PWMS) - Body ground Pattern select switch not turned 10 kΩ or higher
      A35-56 (SPCN) - Body ground Pattern select switch being pushed and held Below 1 Ω
      A35-56 (SPCN) - Body ground Pattern select switch not pushed 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. REPLACE ECM


    1. Replace the ECM.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    PERFORM INITIALIZATION Click here