AUTOMATIC TRANSAXLE SYSTEM, Diagnostic DTC:P062F44

DTC Code DTC Name
P062F44 Internal Control Module EEPROM Data Memory Failure

DESCRIPTION

The ECM monitors its internal operation and will store this DTC if it detects an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P062F44 Internal Control Module EEPROM Data Memory Failure ECM internal error (EEPROM) (1-trip detection logic). ECM Comes on DTC stored SAE: P062F

MONITOR DESCRIPTION

The ECM monitors its internal operation. If the internal operation is malfunctioning, the ECM illuminates the MIL and stores this DTC.

CAUTION / NOTICE / HINT

Note


  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  • Perform registration and/or initialization when parts related to the automatic transaxle are replaced.

    Click here

PROCEDURE


  1. READ OUTPUT DTC (DTC P062F44)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Clear the DTCs.

      Click here


      Powertrain > Transmission > Clear DTCs

    5. Turn the engine switch off and turn the GTS off.

    6. Disconnect the GTS.

    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    8. Connect the cable to the negative (-) battery terminal.

    9. Connect the GTS to the DLC3.

    10. Turn the engine switch on (IG).

    11. Turn the GTS on.

    12. Enter the following menus: Powertrain / Transmission / Trouble Codes.


      Powertrain > Transmission > Trouble Codes

    13. Read the DTCs using the GTS.

      Result
      Result Proceed to
      DTCs are not output A
      DTC P062F44 is output B

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

    B

    REPLACE ECM Click here