VALVE BODY ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL MANUAL VALVE


    1. Coat the manual valve with ATF and install it to the transmission valve body assembly.

  2. INSTALL TRANSAXLE CASE GASKET


    1. Coat 2 new transaxle case gaskets with ATF and install them to the transaxle case sub-assembly.

  3. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


    1. Coat the O-ring of the transmission wire with ATF.

    2. B0059LXC03
      *1 Manual Valve Lever Shaft Sub-assembly
      *2 Manual Valve
      *a Positioning Bolt

      Insert the pin of the manual valve lever shaft sub-assembly into the groove on the end of the manual valve and install the transmission valve body assembly to the transaxle case sub-assembly with the 11 bolts.

      Torque:
      10.8 N*m  { 110 kgf*cm, 8 ft.*lbf }
      Bolt Length
      Bolt Length (mm (in.))
      A 25 mm (0.984)
      B 30 mm (1.181)
      C 35 mm (1.378)
      D 55 mm (2.165)

      Note


      • When installing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and transaxle case sub-assembly to interfere with each other.

      • First, temporarily tighten the bolts marked *a in the illustration because they are positioning bolts.

  4. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY

    Click here