PARK / NEUTRAL POSITION SWITCH ADJUSTMENT

PROCEDURE


  1. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  2. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  4. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  5. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01HFCK

      Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.

    2. A01HF5B

      Loosen the 2 bolts of the park/neutral position switch assembly.

    3. B0058H5C17
      *a Protrusion

      Align the protrusions of the park/neutral position switch assembly.

    4. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.

    5. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the nut and washer.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

    6. After the adjustment, perform the park/neutral position switch assembly operation check.

      Click here

  6. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  9. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here