ATF TEMPERATURE SENSOR

INSTALL ATF TEMPERATURE SENSOR ASSEMBLY

Coat a new O-ring with ATF and install it to the ATF temperature sensor assembly.
Coat the 4 bolts with ATF.

*1

Clamp

Install the ATF temperature sensor assembly and clamp to the transmission valve body assembly with the 4 bolts.

Bolt Length

Bolt	Length (mm (in.))
A	25 mm (0.984)
B	85 mm (3.346)

INSTALL VALVE BODY OIL STRAINER ASSEMBLY

Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.

Note

Ensure that the O-ring is not twisted or pinched.
Install the valve body oil strainer assembly to the transmission valve body assembly with the 2 bolts.

Torque:

10.8 N*m { 110 kgf*cm, 8 ft.*lbf }

INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

Install the 2 transmission oil cleaner magnets to the automatic transaxle oil pan sub-assembly as shown in the illustration.
Clean the contact surfaces of the automatic transaxle assembly and automatic transaxle oil pan sub-assembly.
Clean and degrease the bolt and the bolt hole in the automatic transaxle assembly.
Install a new automatic transaxle oil pan gasket to the automatic transaxle oil pan sub-assembly.
Install the automatic transaxle oil pan sub-assembly with automatic transaxle oil pan gasket to the transaxle case with the 17 bolts.

Torque:

7.5 N*m { 76 kgf*cm, 66 in.*lbf }

Note

Completely remove any oil or grease from the contact surfaces of the transaxle case and automatic transaxle oil pan sub-assembly with automatic transaxle oil pan gasket before installation.
Apply adhesive to the bolt.

Adhesive

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Install the bolt.

Torque:

7.0 N*m { 71 kgf*cm, 62 in.*lbf }

Note

In order to ensure proper sealing of the automatic transaxle oil pan sub-assembly bolt, apply adhesive to the bolt and install it within 10 minutes of adhesive application.