МАСЛЯНЫЙ ПОДДОН СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the oil pan installation/removal are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Removal/installtaion of the radiator grille Television camera view adjustment Panoramic view monitor system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER COVER (for ALPHARD)

    Click here

  2. REMOVE FRONT BUMPER COVER (for VELLFIRE)

    Click here

  3. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH

    Click here

  7. REMOVE TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY


    1. A01IIIM

      Remove the refill plug and gasket from the rear transaxle case.

    2. A01IFWT

      Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the transaxle oil (CVT) pan sub-assembly, and drain the fluid.

    3. A01IK1T

      Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle oil (CVT) pan sub-assembly.

    4. A01IL5IC02
      *1 No. 1 Transmission Oil Filler Tube

      Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly.

      Tech Tips

      Removing the No. 1 transmission oil filler tube will drain all of the fluid in the transaxle oil (CVT) pan sub-assembly.

    5. A01IG6J

      Remove the 19 bolts and transaxle oil (CVT) pan sub-assembly from the transaxle case.

      Note

      Some fluid will remain in the transaxle oil (CVT) pan sub-assembly. Remove all the bolts, and carefully remove the transaxle oil (CVT) pan sub-assembly.

    6. Remove the transaxle oil pan (CVT) gasket.

    7. Temporarily install the gasket and refill plug to the rear transaxle case.

      Tech Tips

      Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.

  8. REMOVE OIL CLEANER (CVT) MAGNET


    1. A01IGRAC02
      *1 Oil Cleaner (CVT) Magnet

      Remove the 2 oil cleaner (CVT) magnets from the transaxle oil (CVT) pan sub-assembly.

    2. Clean off any metal particles adhered to the 2 oil cleaner (CVT) magnets.

    3. Clean the transaxle oil (CVT) pan sub-assembly and remove any metal particles, sludge, etc.