Click here

СТАРТЕР СНЯТИЕ

Click here
Click here Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here
Memorize steering angle neutral point Panoramic view monitor system

Click here
Initialize back door lock Power door lock control system

Click here
Initialize servo motor Air conditioning system

Click here
Reset slide door close position Power slide door system

Click here
Reset back door close position Power back door system

Click here
Replacement of starter assembly Clear Number of Starter Operations Stop and start system

Click here
Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    SEPARATE CENTER NO. 1 COWL TOP VENTILATOR LOUVER

    Click here

  4. Click here

    REMOVE BATTERY


    1. A01UDPU

      Disengage the 2 claws to open the battery terminal cap.

    2. Loosen the nut and disconnect the cable from the positive (+) battery terminal.

    3. Disengage the 2 clamps from the battery clamp sub-assembly.

    4. A01UEM6

      Remove the bolt, nut and battery clamp sub-assembly.

    5. A01UEN0

      Remove the battery insulator from the battery.

    6. Remove the battery and battery tray.

    7. A01UE4G

      Remove the battery clamp bolt from the battery carrier.

  5. Click here

    REMOVE BATTERY CARRIER


    1. A01UE2Y

      Disengage the 2 clamps.

    2. Remove the 5 bolts and battery carrier.

  6. Click here

    REMOVE BATTERY CARRIER SUPPORT


    1. A01UCPY

      Remove the 2 bolts and battery carrier support.

  7. Click here

    REMOVE STARTER ASSEMBLY


    1. A01UF0UC01
      *1 Terminal Cap
      *2 Wire Harness Clamp Bracket

      Remove the terminal cap.

    2. Remove the nut and disconnect terminal 30.

    3. Disconnect the starter assembly connector.

    4. Remove the bolt and disconnect the wire harness clamp bracket.

    5. Remove the 2 bolts and starter assembly.