Click here

ЭЛЕКТРОДВИГАТЕЛЬ ВЕНТИЛЯТОРА СИСТЕМЫ ОХЛАЖДЕНИЯ СНЯТИЕ

Click here
Click here Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cooling fan motor or No. 2 cooling fan motor removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Battery terminal is disconnected / reconnected Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here
Memorize steering angle neutral point Panoramic view monitor system

Click here
Initialize back door lock Power door lock control system

Click here
Initialize servo motor Air conditioning system

Click here
Reset slide door close position Power slide door system

Click here
Reset back door close position Power back door system

Click here
Removal/installtaion of the front television camera assembly or the radiator grille Television camera view adjustment Panoramic view monitor system

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE RADIATOR ASSEMBLY

    Click here

  2. Click here

    REMOVE FAN


    1. A01IJE9

      Remove the nut and fan.

  3. Click here

    REMOVE NO. 2 FAN


    1. A01IL6H

      Remove the nut and No. 2 fan.

  4. Click here

    REMOVE COOLING FAN MOTOR


    1. A01IEUY

      Remove the 3 screws and cooling fan motor.

  5. Click here

    REMOVE NO. 2 COOLING FAN MOTOR


    1. A01IJFM

      Disengage the clamp.

    2. A01IGNH

      Remove the 3 screws and No. 2 cooling fan motor.